Dispensing Bottle and Spout

 For Liquid or Gel Flux

The large spout will fit our 2,4,8,16 Oz bottles of Liquid or Gel Flux. Use this spout to dispense flux, or use to fill smaller 1/2 Oz. bottle. We provide with each order for 1/2 Oz bottle a 3 inch length of small plastic tubing (.0253” 22 gauge (AWG), this can be inserted into the spout for dispensing a small drop of flux. You can also use the spout without the tubing.

Dispensing bottle w/circuit board Large bottle filling dispensing bottle Dispensing bottle 1/2 Oz bottle w/Supersafe™ Flux Empty bottles

HINTS ON INSERTING TUBING INTO TOP

First cut a small length of the tubing and insert a stiff wire into it. I used a needle. Place a pointed tapered object into the tip (I used a metal scribe) and push down a small amount, remove and place the tubing into the opening before it closes. You may need to do this a couple of times to get the opening right. Do not make the opening too large, too large and the tubing will fall out. You can do the same with the large spout, or just drill a hole if just using for filling the smaller bottle.

Dispensing bottle

EMPTY BOTTLES

Purchase Here

Privacy Policy

Guarantee

Disclaimer

Technical Advise

Shipping Information




+

About Us

About Superior Flux

Safety Data & Spec Sheets

What is Flux

Why do I need a Flux

New to Soldering Start

HERE  Soldering Tips

Products:

Superior No.30 Supersafe™

Aluminum Flux

Stainless Flux

Jewelry & Brazing Flux

Solder

RubyFluid   

Tip Tinner       Soder-Wick

Home Pg

Contact Us

Office Hours

E-Mail Us

Customer Comments


Top of Page